Communicate with Supplier? Supplier
Amanda Cao Ms. Amanda Cao
What can I do for you?
Chat Now Contact Supplier
Chengdu JRT Meter Technology Co., Ltd
Home > News > How To Connect a Arduino With JRT Measure Sensor?
Online Service
Amanda Cao

Ms. Amanda Cao

Leave a message
Contact Now

How To Connect a Arduino With JRT Measure Sensor?

2020-03-09
Hi friend,
Nice to meet you, and thanks for choosing Chengdu JRT!
We are the factory and dedicated to laser Distance Sensor since 2004. The distance modules already widely used in many industrial area.
As customers who bought our laser ranging sensors often asked, "does the laser ranging module support to connect Arduino?" Yes, it already connnect to Arduino sucessfully. And so, we will provude you a brief description of how our customers applied Arduino tested our ranging module.
First of all, customers often choose our early 703A version Laser Distance Sensor module.
In addition, the following are some notes for attention before using the module, please refer to the instructions for use:
1. hardware connection, you need to weld these lines :1-power cord, our module power supply is usually 3.0 V or 3.3; 2-ground wire GND; 3-receiving line TX; 4-transmission line continuous measurement control line, boot control line, where power supply 3.0 or so ;(note: if there are other voltage requirements, you can external power supply to achieve) The receiving line RX, wiring of the
2. module should be connected to the location TX the sending line above. The sending line TX, wiring of the
3. module should be connected to the receiving line above the Arduino.
4. our module control command is single character ASCII code, module please do not tick HEX send;
5. ensure that the module has been turned on through the boot control line before sending the command.

How To Connect a Arduino With JRT Measure Sensor

Previous: How To Connect Laser Sensor With PLC?

Next: What are the future applications of lidar sensors?

Home

Phone

Skype

Inquiry